AUTOMODELS

Model histories317

The history of cars: their origins, development and technical features. Page 14.

ZIS-16

ZIS-16

An urban bus using ZIS-5 components had a heavy wood-framed, steel-clad body. The ZIS-16 therefore received vacuum assistance for its mechanical brakes and a more powerful engine than the preceding ZIS-8. The ZIS-5 engine was uprated by rai...

Read more →
YaTB-3

YaTB-3

The first domestically built double-deck trolleybus had unusually left-offset drive-axle gearboxes, an inter-axle differential, single rear tyres and pneumatic doors and brakes. The lower deck, 1,780 mm high, seated 32; the upper deck, reac...

Read more →
MTB-82D

MTB-82D

For a long period this was the principal urban trolleybus in the USSR. It was initially built at the Moscow Engineering Plant and, from 1951, at the Uritsky Works in Engels.

Read more →
ZIS-Aremkuz

ZIS-Aremkuz

Moscow’s bus-body repair works, Aremkuz built city buses using components from the ZIS -5V, following the ZIS-16 layout. The first batch marked Moscow’s 800th anniversary.

Read more →
GZA-651

GZA-651

The model 651 bus for local services was initially produced as the GZA-651 at the Gorky Bus Plant, later GZSA, and from 1950 at PAZ.

Read more →
RAF-251

RAF-251

Riga Motor Repair Plant No. 2, later RAF, built this bus on a GAZ-51 chassis with the frame extended at both ends. Its forward-control wood-and-metal body had one side door.

Read more →
LAZ-695

LAZ-695

The first domestic production bus with welded rather than riveted body panels. Features of the LAZ-695: rear power unit, semi-integral body with rectangular-tube frame, rigid axles on leaf springs with auxiliary coils and curved side glazin...

Read more →
ZIL-158

ZIL-158

A city bus with a unitary body and cladding riveted to its frame. The engine sat front right, the propeller shaft had an intermediate bearing, and brakes and doors were pneumatic.

Read more →
ZIL-159

ZIL-159

An experimental city bus with rear power unit, hydromechanical transmission, power steering and air brakes. It used an experimental V-engine. Inside the ZIL-159, single seats ran along the left and double seats along the right. Both doors h...

Read more →
ZiU-6

ZiU-6

An experimental city bus sharing components with the ZiU-5 trolleybus. Two ZIL-158 engines were coupled in tandem through a fluid coupling along the left side. Other features of the ZiU-6 were remote electropneumatic gear selection, a unita...

Read more →
SVARZ-TS1

SVARZ-TS1

The first domestic articulated trolleybus was built by Moscow’s Sokolniki carriage repair works ( SVARZ ). Features included independent coil suspension for three steered wheel pairs, hydropneumatic brakes and separate hub reductions. The s...

Read more →
LiAZ-5E-676

LiAZ-5E-676

LiAZ-5E-676 was an experimental articulated bus for large cities. Its front section followed the Likino plant’s usual design. The first and third axles steered, as on most articulated buses. LiAZ developed it jointly with NAMI’s bus design...

Read more →