The influence of French designer Jean-Pierre Grégoire is evident in the Dyna 54, which replaced the 1946 Dyna 110 (Za Rulem, 1995, No. 1). Its unitary body was welded from aluminium pressings. Steel tubular crossmembers bolted to its centre...
Read more →
This ambulance based on the GAZ-MM (Za Rulem, 1976, No. 3) had softer springs, rear hydraulic dampers, ventilation and a heater. It was widely used to evacuate wounded personnel during the war.
Read more →
This heavy armoured car used a modified ZIS-6 chassis (Za Rulem, 1981, No. 3). Its low hull with sloping 13 mm armour plates was advanced for its time.
Read more →
The vehicle pictured is a version of the GAZ-MM, built in the first years of the Soviet–German war. Compared with the pre-war truck, it had a canvas cab roof and sides, welded wings, fixed body sides and a simplified chassis without a bumpe...
Read more →
This half-track was based on the ZIS-5V (Za Rulem, 1977, No. 8). Its 415 mm-wide rubber tracks carried metal shoes. Mechanical brakes acted on the rear axle, which drove the two track sprockets through chains.
Read more →
After the war, Soviet industry began producing special wheeled vehicles for the armed forces. At the military parade on Red Square in November 1951, infantry already rode in new domestically built armoured personnel carriers.
Read more →
The BTR-152V armoured personnel carrier was also based on components from an off-road truck. Early BTR-152 vehicles had 9.00–20 tyres, without a winch or central tyre-pressure control. On the BTR-152V pictured, air was supplied externally;...
Read more →
In 1912 the military ordered staff cars from the Russo-Baltic Wagon Works, the first domestically built army vehicles. They were seventh-series S24-30s equipped with searchlights, pull-out map tables, document boxes and a wicker basket on t...
Read more →
The first Soviet armoured car, the BA-27, used a modified AMO-F15 chassis with strengthened frame and springs, higher-capacity tyres, electric starter, extra fuel tank and electric lighting. Armour was 4–7 mm thick.
Read more →
This experimental off-road truck was among the world's first four-axle all-wheel-drive vehicles. It shared many components with the three-axle YaG-10 (Za Rulem, 1979, No. 2). The YaG-12 had De Dion suspension for both front wheel pairs, dou...
Read more →
A three-axle truck based on the ZIS-5 (Za Rulem, 1976, No. 3), widely used by the Red Army for transport and special equipment, including the first Katyusha launchers. Unlike the ZIS-5, the ZIS-6 had worm final drives, a two-speed range uni...
Read more →
A three-axle off-road truck based on the GAZ-AA (Za Rulem, 1976, No. 3). Early engines gave 40 hp, rising to 50 hp in 1936. The chassis served armoured cars, radio vehicles and anti-aircraft mounts.
Read more →