AUTOMODELS

Model histories317

The history of cars: their origins, development and technical features. Page 22.

BA-20

BA-20

A light armoured car on GAZ-M1 chassis (Za Rulem, 1976, No. 4). Before the war, the BA-20 was widely used by the Red Army for reconnaissance and patrols. The hull was welded from 6 mm armour. A rotating turret housed the machine gun; its sh...

Read more →
GAZ-05-193

GAZ-05-193

A staff bus on the three-axle GAZ-AAA chassis (Za Rulem, 1981, No. 4), with a modified 17-seat GAZ-03-30 body. Besides special equipment, the interior had an independent heater. Two spare wheels were carried.

Read more →
BA-10

BA-10

A medium armoured car on a modified GAZ-AAA chassis with shortened frame, reinforced front axle beam and GAZ-M1 dampers. Tracks could be fitted over the driven rear wheels for rough terrain.

Read more →
GAZ-64

GAZ-64

A command jeep using production GAZ-M1 and GAZ-61 components. The GAZ-64 had ball-type front constant-velocity joints and a live front axle on four longitudinal quarter-elliptic leaf springs.

Read more →
BA-64B

BA-64B

A light armoured car based on the GAZ-67. Its predecessor, the GAZ-64-based BA-64, was the first Soviet production all-wheel-drive armoured car. Small numbers of two BA-64B variants were built: a six-person troop carrier without turret or r...

Read more →
GAZ-63A

GAZ-63A

The GAZ-63A off-road truck shared many GAZ-51 parts (Za Rulem, 1976, No. 9). It was the first Soviet production truck with single rear wheels. The front drive used ball-type constant-velocity joints.

Read more →
ZIS-151

ZIS-151

The first Soviet production truck with three driven axles. Its rear bumper was level with the front, allowing another ZIS-151 to push it through difficult terrain.

Read more →
BAV

BAV

Soviet production of this large amphibian began in 1950 using truck components. Its watertight steel hull provided buoyancy. A 635 mm propeller drove it afloat, with a vertical rudder for steering.

Read more →
YaAZ-210G

YaAZ-210G

This ballast tractor hauled heavy indivisible loads on a three-axle MAZ-5320 trailer or three-axle, 24-wheel MAZ-5208 heavy transporter. Eight tonnes of ballast on its steel platform gave the driven rear bogie sufficient traction.

Read more →
ZIS-32

ZIS-32

NATI developed the first Soviet 4×4 truck from the ZIS-5, adding a driven front axle with GAZ-AA-derived final drive and Rzeppa constant-velocity joints. The NATI-K2 also received a two-speed transfer case.

Read more →
ZIS-253

ZIS-253

This Moscow-designed model was initially intended for UAZ, then another plant, but never entered production. Its two-stroke diesel shared many components with the YaAZ-204. Other features of the ZIS-253 were an overdrive fifth gear, 12-volt...

Read more →
ATUL L-1

ATUL L-1

The Leningrad city executive committee's transport administration ( ATUL ) built over 100 city buses at its repair and body plants from 1946. These were the first Soviet production forward-control vehicles. The L-1 used a modified ZIS-5 cha...

Read more →